You may print this page for your file
You may print this page for your file
Hysol ® 0430
Hot Melt Adhesive
Description
Hysol Spraypac™ 0430 is formulated to be spray applied to a wide variety of substrates using the Hysol 4210 Spray Tool™. SprayPac 0430 is suitable for bonding expanded polystyrene or urethane foams, corrugated, wood, fabrics and plastics. SprayPac 0430 can be used in most applications where solvent-based aerosols are used.
Typical Properties
Test Method
Softening Point, RB, F 240 ASTM E28
Viscosity @ 330F, cps 6,250 ASTM D3236
@ 350F 4,000
@ 375F 2,950
@ 400F 2,100
Heat Resistance, Pine, 2 psi load 170 ASTM D 4498 (2 lbs.)
Open Time, sprayed, minutes 3.5
Molten Tack High
Performance Characteristics
Lap Shear Strength, psi ASTM D 3163
Pine 315
Polypropylene 277
HDPE 217
Polycarbonate 270
Application
Best results are achieved when sprayed 6-9" above the substrate. A one inch high pattern is optimum. Adjust set screw on the Hysol 4210 SprayToolTM counter clockwise to increase spray width or clockwise to dispense a bead. Apply at 360F using thermostat part # EST005. Use cartridges well dusted with talc the powdery material which coats cartridges as recieved.
Availability
Polyshot Cartridges for the Spray Tool™
Technical Consultation Service
Our technical staff and representative are ready to assist in solving any special bonding requirements. You are invited to take advantage of our extensive experience, laboratory services and trained field service staff. Call
800.323.5158 now and let us help you with your adhesive needs.
DISCLAIMER: The information supplied in this document is for guidance only and should not be construed as a warranty. All implied warranties
are expressly disclaimed. Including without limitation any warranty of merchantability and fitness for use: All users of the materials are responsible
for assuring that it is suitable for their needs, environment and use. All data is subject to change as Dexter deems appropriate.
Users should review the Material Safety Data Sheet (MSDS) and product label for the material to determine possible health hazards, appropriate
engineering controls and precautions to be observed in using the material. Copies of the MSDS and label are available upon request.
______________________________________________________________________
For
more information or to order contact the Glu Guru™ at 1-800-323-5158
or Email
mike@on-hand.com