|
 
You may print this page for your file
Hysol ® 7460
Hot Melt Adhesive
Typical Properties
Test Method
Softening Point, RB, F 275 ASTM E28
Viscosity @ 350F, cps 6700 ASTM D3236
Heat Resistance, Pine, 2 psi load 210 HTPSK-1
Open Time, Sprayed, Seconds 30
Application Temperature,F 400
Application
Best results are achieved when sprayed 3-9" above the substrate. Apply at 400F with the Hysol 4210 series Spray Tool™. Apply at 350F - 375F in a bulk applicator.
Availability
Polyshot Cartridges for the Spray Tool™ Pellets for bulk applicators.
Technical Consultation Service
Our technical staff and representative are ready to assist in solving any special bonding requirements. You are invited to take advantage of our extensive experience, laboratory services and trained field service staff. Call
800.323.5158 now and let us help you with your adhesive needs.
DISCLAIMER: The information supplied in this document is for guidance only and should not be construed as a warranty. All implied warranties
are expressly disclaimed. Including without limitation any warranty of merchantability and fitness for use: All users of the materials are responsible
for assuring that it is suitable for their needs, environment and use. All data is subject to change as Dexter deems appropriate.
Users should review the Material Safety Data Sheet (MSDS) and product label for the material to determine possible health hazards, appropriate
engineering controls and precautions to be observed in using the material. Copies of the MSDS and label are available upon request.
For
more information or to order contact the Glu Guru™ at 1-800-323-5158
or Email
mike@on-hand.com
| 
The Glu
Guru™
Adhesive Tech Center
